CP Primer
CP Primer is a high quality, low viscosity resin/ rubber solution for priming surfaces prior to the application of Colas Preformed Surface Dressing and Colasgrip.
It should also be used for the priming of joints prior to the application of Colas Jointfill A2, Jointfill N1 and Coljoint N2 sealant.
Surfaces must be clean and free from dust, oil and fuel spillage.
CP Primer can be applied by either brush or roller to damp but not wet surfaces. It should be applied at ambient temperatures of between 2°C and 30°C.
PREFORMED SURFACE DRESSING
Apply CP Primer as thinly and evenly as possible and allow to become touch dry before applying the Preformed Surface Dressing. Applying too much could result in the primer bleeding through or the de-bonding of the Preformed Surface Dressing.
COLASGRIP
For concrete surfaces apply CP Primer as thinly and evenly as possible and allow to become touch dry before applying Colasgrip.
JOINT SEALING
Allow the CP Primer to dry completely, allowing a minimum of 30 minutes on a dry surface or 90 minutes on a damp surface before applying sealant. Apply sealant within 6 hours. A spread rate of 0.1-0.2l/m2 should be achieved depending on the porosity of the base. Cellulose thinners should be used to clean tools.
CP Primer should be applied as thinly and evenly as possible to achieve a coverage rate of 0.1–0.2l/m2.
CP Primer is available in 5 litre metal containers (4 per box).
CP Primer has a 12 month storage life in original unopened containers. Protect from frost and direct sunlight.
CP Primer is produced to a manufacturing system accredited to ISO9001.
For full safety information, please request the CP Primer Safety Data Sheet 05 using the contact information at the back of this brochure.
